With no PEEK or PTFE in hot regions, you can reach 300C with the supplied thermistor. By swapping a thermistor for a thermocouple (may require additional electronics) you can reach over 400C.
This not only allows you to print extremely high temperature materials like Polycarbonate and Nylons but also eliminates HotEnd meltdown failures associated with PEEK/PTFE designs. There is no risk of damaging the PTFE liner through overheating.
Go from 20C to 200C in just 65 seconds - temperature control is responsive enough that you can keep the hotend within 0.5C of your set temperature or less with ease.
E3D V6 1.75MM HOTEND ASSEMBLY - TECHNICAL SPECIFICATIONS: |
|
|
– Aluminium |
|
– Aluminium |
|
– Stainless Steel |
|
– Brass |
|
– 12V 40W |
|
– Up to 300°C Stock |
|
– 1.75mm |
|
– 62mm ±1mm L / 12mm Neck Diameter
|
E3D V6 1.75MM HOTEND ASSEMBLY INCLUDES: |
|
|
– E3D V6 Cooling Tower for 1.75mm |
|
– 0.4mm |
|
– 100k 1% NTC |
|
– E3D V6 Heater Block |
|
– E3D V6 1.75mm Heat Break |
|
– 30mm |
|
– E3D V6 Fan Shroud |
- N/A
More from this Category
RAMPS LCD Control Panel (12864 LCD)
3D Printer Build Surface Heat Bed Sticker (214mmx214mm, Mk3)
RAMPS 1.4 ARDUINO SHIELD
GT2 Timing Belt & GT Pulley Set (16Teeth, 5mm Bore, 5Meters)
BigTreeTech SKR 1.4
E3D V6 1.75MM HEAT BREAK
E3D V6 Direct Drive Extruder Radiator Cooling Tower (1.75mm, M7)
